- The soil may be hard where there has not been recent rain. It will be important for the sampler to make certain that the core is the correct depth and not to give up if the going gets tough. If a core comes out of the sampling tube incomplete, discard it and redo the sample a few feet over.
- Don’t work the land before the sampler arrives. The ability to take a 0-6 inch core required for P, K, organic matter, zinc, and surface nitrates (necessary for sugar beet recommendations) is much degraded if the soil is worked, particularly after chisel plowing or (God forbid) deep chiseling or plowing.
- When sampling, do not take samples from the headlands, or the turn rows around sloughs, because these areas have legacy overlap inherent with fertilizer/manure application. Make a mental note not to sample within 100 feet roughly of the edge of the field or around obstacles that would have resulted in applicator turning. The exception to this is in zone sampled fields with salty areas next to roads/sloughs. These should be sampled as a zone, because the NPK fertility in these areas will probably be vastly different than the rest of the field and fertilizer savings can be achieved by identifying these areas.
- To build zones, use multi-year yield mapping data, aerial imagery of growing crops, satellite imagery from growing crops, soil EC or EM sensor data if available, and topography if it can be identified and properly modeled (raw elevation data should not be used as it usually does not indicate a landscape position). The Web soil survey should not be used as a first zone development tool. It was not designed for this purpose and the boundaries are usually misleading.
- Know that nitrate sampling, or sampling for K for that matter, are moving targets and there is a plus-minus value at the end of analysis. Persistent dry weather after sampling will result in a spring value that is similar in nitrate to what is found now. Wetter weather may result in a bloom of nitrate, but this late in the season the increase in nitrate will be small, if seen at all. Nitrate may be immediately tied up in residue breakdown, with the awakened microorganisms that have been dormant all season. K values are at their lowest now through early September and if it stays dry, the K values will be low through fall. However, freeze-thaw and any moisture during winter/early spring will increase values, so next April the highest K values of the year are seen. It is best to analyze for K at about the same time during the year each time K is analyzed (it doesn’t have to be every year) to make sure that the relative values of K can be tracked and not be confusing.
https://northarvestbean.org/wp-content/uploads/2021/08/IMG_5813-scaled.jpg 2560 1920 Red River Farm Network https://northarvestbean.org/wp-content/uploads/northarvest-bean-logo.png Red River Farm Network2021-08-12 19:28:412021-08-20 19:30:57Soil Sampling Tips
Due to the large amount of residual nitrate left after the short crops in the state, there will be more soil sampling than usual. Here are a few tips to increase the practical use of the results from sampling.
(Source: Dave Franzen, NDSU Extension)